Ethernet Configuration - Cisco TelePresence 7010 Help Manual

Network settings
Table 10: IPv6 configuration
Field Field description
IP Select Disabled, Automatic via
configuration SLAAC/DHCPv6 or Manual.
If you select Manual, you must also supply the
IPv6 address, prefix length and default
gateway.
If you select Automatic via SLAAC/DHCPv6,
the TelePresence Server automatically gets
an IPv6 address. It uses SLAAC, Stateful
DHCPv6 or Stateless DHCPv6 as indicated
by the ICMPv6 Router Advertisement (RA)
messages (see Automatic IPv6 address
preferences below).
IPv6 address If you chose Manual configuration, supply the
IPv6 address in CIDR format, for example
fe80::202:b3ff:fe1e:8329.
Prefix length If you chose Manual configuration, supply the
prefix length.
Default (Optional) Supply the IPv6 address of the
gateway default gateway on this subnet.
IP status
The IP status section shows the current IP settings for this Ethernet port of the TelePresence Server, as
follows, whether they were automatically or manually configured.
IPv4 settings:
DHCP
n
IP address
n
Subnet mask
n
Default gateway
n
IPv6 settings:
DHCPv6
n
IPv6 address
n
IPv6 default gateway
n
IPv6 link-local address
n

Ethernet configuration

Configure the Ethernet settings for this port of the TelePresence Server, and then click Update Ethernet
configuration.
Cisco TelePresence Server 7010 and MSE 8710 in Remotely Managed Mode Printable Help (4.0)
Usage tips
Disable IPv6 on the port if the network does
not support IPv6.
You can disable IPv6 on the TelePresence
Server port but only if logged in using IPv4.
You only need to enter an address if you
chose Manual IP configuration. If you chose
Automatic via SLAAC/DHCPv6, a manually
entered setting is ignored.
The prefix length is the (decimal) number of bits
that are fixed for this address.
The address may be global or link-local
Page 17 of 92