Diagnostic Test - Avery Dennison Monarch 9485 User Manual

3-9. Diagnostic Test

Turn off the printer.
The information label prints.
12
Press and hold the feed
button and power button.
1 2
3
NOTE
1. For Hex Dump mode, do steps 1-2 then
press the feed button.
2. After printing ASCII pattern,
the diagnostic test is complete.
3. If the feed button is not pressed to go to
Hex Dump mode, the printer exits
diagnostics after three seconds.
The sample of self test printout
Upon initial installation or for troubleshooting, you can run the diagnostic test to get
information about:
Firmware version, emulation, codepage, sensor settings, interface settings, etc.
If no issues are found with diagnostic test, examine other devices and software.
The diagnostic test is working independent of devices and software.
Do not overheat the motor
●
To prevent the motor from overheating, stop the printer for at least 30 seconds
after continuously printing 1.5 meters.
13