3-7. Peel Mode
Peel Mode
With a roll of stock installed, slide the
peeler body towards the back of the
printer.
Non-Peel Mode
Lift the peeler wing and slide the peeler
body towards the front of the printer.
10
Push the peeler body until you see two
complete triangles. Press the feed button.
1 2
1 2
Press the feed button.
3-8. Shoulder Strap Installation
Optional
Insert the strap into the hook of the printer.
1
2
Place the end of the strap into
the hook of shoulder strap.
3
After pulling out the end of the
strap tightly, put it into the clip
to be fastened.
11