Hi-Z Sync And Hv Hi-Z Sync I/O Boards; Applicability Notice - AMX Optima Instruction Manual

Hi-Z Sync and HV Hi-Z Sync I/O Boards

Applicability Notice

FIG. 28
Hi-Z sync and HV Hi-Z sync boards
This chapter pertains to Optima Hi-Z and HV Hi-Z sync input/output boards contained in pre-engineered
systems and custom systems. The table below provides information on the types of Hi-Z and HV Hi-Z sync
boards and their numbers.
The 8x8 HV Hi-Z sync board (FG1046-443) routes both H and V signals. All larger configurations require
two Hi-Z sync boards in an enclosure: one board for the H signal and one for the V signal.
Hi-Z Sync and HV Hi-Z Sync I/O Boards
Note: Specifications for these boards are listed on page 52.
Configuration
8x8 HV
Note: Wideband (300 MHz) systems can use Hi-Z sync or HV Hi-Z sync boards to route horizontal and
vertical sync signals.
Optima Instruction Manual
16x16
16x24
20x4
20x20
24x4
24x16
36x4
Hi-Z Sync and HV Hi-Z Sync I/O Boards
HI-Z sync boards
(shown with audio board)
HV Hi-Z HV sync board
(shown with wideband video boards)
Board Part #
FG1046-443
FG1046-569
FG1046-566
FG1046-563
FG1046-560
FG1046-557
FG1046-554
FG1046-551
51