Catpro Rgbhv+Stereo Rx Module Specifications - AMX Optima Instruction Manual

RGBHV+Stereo to CatPro I/O Boards (with RX Modules)

CatPro RGBHV+Stereo RX Module Specifications

Applies to: CatPro RX Module FG1010-48-01.
General Specifications
Approvals
Signal Types
Maximum Resolution
Supported Twisted Pair Cable
Types
Power In Connector
Power Consumption (max.)
Thermal Dissipation (max.)
Humidity
Operational Temperature
Dimensions
Depth
Width
Height
Weight
* When used in conjunction with an AMX AutoPatch Distribution Matrix, the overall cable length cannot exceed
1,000 feet (305 m).
RGBHV+Stereo Audio Specifications at 1000 ft. (305 m)
Parameter
RGB Out
Signal Level Range
Impedance
Signal to Noise Ratio (SNR)
Skew Adjustment
Sync Out
Signal Level
Polarity
Audio Out
Signal Level (max.)
Frequency Response
THD+Noise
Signal to Noise Ratio (SNR)
Impedance
Volume Adjustment Range
Connector Types
RGBHV+Stereo In
RGBHV Out
Stereo Audio Out
AMX reserves the right to modify its products and their specifications without notice.
96
CE, UL, cUL
RGBHV, stereo audio (audio is unbalanced)
1600x1200 (4:3) and 1920x1080p (16:9) @ 60 Hz up to 1000 ft. (305 m)*
Cat5, Cat5e, Cat6, Cat6e, and STP
(skew-free cable is not recommended)
All measurements were taken using Cat5e cable.
2.1 mm DC power jack
+12 V to +24 V DC @ 6 Watts
20 BTU/hr.
0 to 90% non-condensing
32° F to 110° F (0° C to 43° C)
5.15 in. (13.08 cm)
5.80 in. (14.73 cm)
1.66 in. (4.221 cm) w/out feet
Approx. 1.3 lb. (0.6 kg)
Conditions
Terminated, user adjustable with gain
and peak
User adjustable
Unterminated
Active high or low
20 Hz to 20 kHz
f = 1 kHz, Vin = -10 dBu to +4 dBu
f = 20 Hz to 20 kHz, Vin = +4 dBu
User adjustable with the RX Module
Value
+0.75 V to -0.3 V typical
75 ohms
>50 dB
0 to 62 ns in 2 ns increments on
R, G, and B channels
Low = 0 V, High = +5 V
Output polarity follows input polarity
+8 dBu
<±0.2 dB
<0.04%
>105 dB
<5 ohms
Mute to +6 dB
RJ-45
HD-15
Pluggable 3-position terminal block
Optima Instruction Manual