Connecting to the Network Port
The DVR can be networked using the 10/100Mb Ethernet connector. Connect a CAT5
cable with an RJ45 jack to the DVR connector. The DVR can be networked with a
computer for remote monitoring, searching, configuration and software upgrades. See
Chapter 3, Configuration
Caution
Connecting Alarms
30
Figure 2-8
Network Connector
for configuring the Ethernet connections.
The network connector is not designed to be connected directly
with cable or wire intended for outdoor use.
Figure 2-9
Alarm Input Connectors
Note
To make connections on the Alarm Connector Strip, press and
hold the button and insert the wire in the hole below the button.
After releasing the button, tug gently on the wire to make certain
it is connected. To disconnect a wire, press and hold the button
above the wire and pull out the wire.
HRXDS Series DVR User Guide