Table of Contents
Advertisement
Troubleshooting
Troubleshooting
Document 800-00919 Rev F
02/08
Problem
No Power
No Live Video
Live Video Very Bright
DVR has stopped recording
DVR displays an error
message stating that the last
recorded image date and
time is later than the current
date and time setting of the
DVR.
Possible Solution
•
Check power cord connections
•
Confirm that there is power at the outlet
•
Check camera video cable and
connections
•
Check monitor video cable and
connections
•
Confirm that the camera has power
•
Check camera lens settings
•
Check CVBS/VGA switch settings
If a cable is attached to the "Loop" connector,
ensure that it is connected to a properly
terminated device.
If hard disk drive is full, you need to either
delete video or set the DVR to the Overwrite
Mode.
The DVR automatically resets the time and
date of the unit, according to the time and date
of the last recorded image.
If this is not the correct time and date, reset the
time and date manually.
If the correct time and date is earlier than the
last recorded image, any video with a later
time and date is lost when resetting the correct
time and date.
C
123
Advertisement
Table of Contents
