Table 3-1 Dvr Front Panel Controls - Honeywell HRSD4 User Manual

Configuration
Control
Camera Buttons (1 to 4)
Power LED
ALARM LED
RECORD LED
MENU Button
QUAD/SEQUENCE Button
32
Note A separate ALARM button is not provided. Press any key on the
front panel or remote control to reset alarm output, including the
internal buzzer, when the alarm is activated. However, when you
are in the menu or PTZ mode, you have to exit the menu or PTZ
mode first to reset alarm output.
Note The sensor for the infrared remote control is to the left of the
MENU button on the front of the VCR. Ensure that nothing
blocks the sensor, or the remote control will not function
properly.
Table 3-1 DVR Front Panel Controls
Function
Press an individual camera button to display a selected camera full
screen.
Use the camera buttons to enter passwords (which contain only
numbers).
Use the camera buttons in the PTZ mode in the following ways:
• Camera 1 zooms in
• Camera 2 zooms out
• Camera 3 controls near focus
• Camera 4 controls far focus
The POWER LED lights when the unit is On.
The ALARM LED lights when alarm output or internal buzzer is
activated.
The RECORD LED lights when the DVR is recording. When the DVR
is in the panic recording mode, the RECORD LED flickers.
Press Menu to enter the Main Menu. You need to enter the
administrator password to access the Main Menu.
Press Menu again to close the current menu or setup dialog box.
You can also use Menu to display the Search Menu in the playback
mode, and load the PTZ Menu in the PTZ mode.
Press Quad/Sequence to toggle between quad (2x2) display mode
and sequence mode.
Quad/Sequence also loads a Preset when the DVR is in PTZ mode.