Connecting Alarm Inputs; Figure 2-6 Video Out Connectors; Figure 2-7 Vga Connector - Honeywell HRSD4 User Manual

Installation
Connecting the RGB Monitor
A VGA port is provided for RGB monitor output. Connect the RGB monitor to the VGA
connector if required. Connect an RGB cable with a DB-15 (male) connector, which is
usually less than 10 feet, to the DVR connector.

Connecting Alarm Inputs

26
Figure 2-6 Video Out Connectors
Note For SPOT monitor Output, set the CVBS/VGA selector switch to
CVBS.
Figure 2-7 VGA Connector
Note For RGB monitor output, set the CVBS/VGA selector switch to
VGA.
Note To make connections on the Alarm Connector Strip, press and
hold the button and insert the wire in the hole below the button.
After releasing the button, tug gently on the wire to make certain
it is connected.
To disconnect a wire, press and hold the button above the wire
and pull out the wire.