Connecting With Your Devices - Christie LW751i Setup Manual

Connecting with your devices

Before connecting the projector to a device, consult the manual of the device to
confirm that the device is suitable for connecting with this projector and prepare
the required accessories, such as a cable in accord with the signal of the device.
Consult your dealer when the required accessory did not come with the projector or
the accessory is damaged.
After making sure that the projector and the devices are turned off, perform the
connection, according to the following instructions. Refer to figures F-1 to F-9 at the
back of this manual.
For details, see User's Manual - Operating Guide. Before connecting the projector
to a network system, be sure to read User's Manual - Network Guide too.
WARNING ►Use only the appropriate accessories. Otherwise it could
cause a fire or damage the projector and devices.
• Use only the accessories specified or recommended by the projector's
manufacturer. It may be regulated under some standards.
• Neither disassemble nor modify the projector and the accessories.
• Do not use the damaged accessory. Be careful not to damage the accesso-
ries. Route a cable so that it is neither stepped on nor pinched.
►Heat may build up in the USB wireless adapter, to avoid possible burns dis-
connect the projector power cord for 10 minutes before touching the adapter.
• When using the USB wireless adapter, use the supplied adapter cover or
terminal cover (10, 11).
CAUTION ►For a cable with a core at only one end, connect the end with
the core to the projector. That may be required by EMI regulations.
►Before connecting the projector to a network system, be sure to obtain the
consent of the administrator of the network.
►Do not connect the LAN port to any network that might have the excessive
voltage.
►The designated USB wireless adapter that is sold as an option is required to use
the wireless network function of this projector. Before connecting the USB wireless
adapter, turn off the power of the projector and disconnect the power cord.
NOTE • Do not turn on or off the projector while connected to a device in
operation, unless that is directed in the manual of the device.
• Some input ports are selectable in the use. For details, see User's Manual -
Operating Guide.
• Be careful not to mistakenly connect a connector to a wrong port.
http://www.pureglare.com.au
LWU701i/LW751i/LX801i/LWU601i/LW651i
Setup Guide
9
020-000792-02
LIT GUID SET D2