Register Structure - TDK-Lambda Z+ series User Manual

TRIGger
[:START]
:DELay <NR3>
:DELay?
:SOURce <CRD>
:SOURce ?
WAVE
:COUN <NR1>
:COUN?
:CURR <NR1>
:CURR?
:LOAD <NR1>
:STEP <CRD>
:STEP?
:STORe <NR1>
:TIME <NR1>
:TIME?
:VOLT <NR3>
:VOLT?
GLOBal
:OUTPut
[:STATe] <bool>
:VOLTage
[:AMPLitude] <NR3>
:CURRent
[:AMPLitude] <NR3>
:*SAV <NR1>
:*RCL <NR1>
:*RST

4.4 Register Structure

Refer to Fig.3-1.
Refer to section 9 of Z
+
series User Manual.
Run trigger
Set trigger delay
Set trigger delay query
Set trigger source
Set trigger source query
Set the number of times that waveform is executed before it is
completed.
Set the number of times that waveform is executed before it is
completed query.
This command specifies the output current points in a list.
This command specifies the output current points in a list query.
Loads from memory WAVE type.
Determines if a trigger causes to next point or through all points.
Determines if a trigger causes to next point or through all points.
Saves data under specified numbers <1..4> of the last WAVE typed
Set the slope time of the waveform.
Set the slope time of the waveform query.
Specifies the output voltage points in a waveform list.
Specifies the output voltage points in a waveform list query.
Set all Power Supply Output On /OFF
Set all Power Supply output voltage
Set all Power Supply output current
Same as *SAV <NR1>
Same as *RCL <NR1>
Same as *RST
11