TDK-Lambda Z+ series User Manual page 11

LIST
:COUN <NR3>
:COUN?
:CURR <NR3>
:CURR?
:DWEL <NR3>
:DWEL?
:LOAD <NR1>
:STEP <CRD>
:STEP?
:STORe <NR1>
:VOLT <NR3>
:VOLT ?
STATus
:OPERation
[:EVENt]
:CONDition?
:ENABle <NR1>
:ENABle?
:QUEStionable
[:EVENt]
:CONDition?
:ENABle <NR1>
:ENABle?
SYSTem
:ERRor:ENABle
:ERRor?
:LANGuage
:REMote
[:STATe] <CDR>
[:STATe]?
:VERSion?
:DATE?
:PON:TIME?
Set the number of times the list is executed before it is completed.
Set the number of times the list is executed query
Specifies the output current points in a list.
Specifies the output current points in a list query.
Specifies the time interval that each point of a list is to remain in effect.
Specifies the time interval that each point of a list is to remain query.
Loads from memory LIST type.
Determines if a trigger causes to next point or through all points.
Determines if a trigger causes to next point or through all points query.
Saves data under specified numbers <1..4> of the last LIST typed
Specifies the output voltage points in a list.
Specifies the output voltage points in a list query.
Returns the value of the event register
Returns the value of the condition register
Set current value for trigger pending
Enables specific bits in the Event register
Enables specific bits in the Event register query
Returns the value of the event register
Returns the value of the condition register
Enable specific bits in the Event register
Enables specific bits in the Event register query
Enable Error Message
Read system error. Refer to table 9-6 of
Switch to GEN Language
Set program communication mode
Set program communication mode query
+
Z
Main software revision
Calibration date
Operation time from first power on applied
10
+
Z
series User Manual