HP Integrity BL860c i2 User's & Service Manual page 98

LOCATOR Identifies the
system/partition and will
blink while a firmware
update is in progress.
NOTE:
partition show the same
LOCATOR status at all
times.
NOTE:
the UID in software from
either the iLO 3 TUI or
web GUI. There is no
UID hardware button on
the server blade itself to
turn it on or off.
POWER Identifies the
system/partition power
state.
98 Troubleshooting
UID LED on the front
panel of the
individual blade
Locator UID in iLO 3
All blades in a
Virtual Indicator in
the Onboard
Administrator's
interface
You can toggle
Monarch Power
button LED on the
front panel of the
Monarch blade
System Power LED in
the iLO 3 GUI
On The system/partition is identified.
Off System/partition is not identified and no
firmware update is actively writing to any
of the system ROMs
Flashing Power should not be interrupted; firmware
is actively burning a ROM.
NOTE: On ProLiant servers this LED
blinks to indicate remote management;
however this is not currently a supported
indication on Integrity servers.
ON/OFF Toggles the current LED state to indicate
toggle transitional mode states activated by a
push and hold of the Physical Presence
button.
If the Locator is off it will toggle on and
then off, but if the Locator is on, it will
toggle off and then on. If the Locator is
flashing, no action will be taken.
Steady System/partition is fully powered on.
green
Steady System/partition is in standby.
amber
Off The system/partition is powered off.