Accessing Uefi Or The Os From Ilo 3 Mp - HP Integrity BL860c i2 User's & Service Manual

Using iLO 3, you can:
Remotely power on, power off, or reboot the host server.
Send alerts from iLO 3 regardless of the state of the host server.
Access advanced troubleshooting features through the iLO 3 interface.
For more information about iLO 3 basic features, see the iLO 3 documentation on the HP website
(http://www.hp.com/servers/lights-out).

Accessing UEFI or the OS from iLO 3 MP

UEFI is an architecture that provides an interface between the server blade OS and the server
blade firmware. UEFI provides a standard environment for booting an OS and running preboot
applications.
Use this procedure to access UEFI or the OS from the iLO 3 MP. Your security parameters were
set regarding remote access.
1. Retrieve the factory iLO 3 password from the iLO 3 Network pull tab located on the right side
of the Monarch blade.
2. From the MP Main Menu, enter co to access the Console.
NOTE:
optimal viewing of the console at UEFI.
3. After memory test and CPU late self test the following message appears:
Press Ctrl-C now to bypass loading option ROM UEFI drivers.
The prompt will timeout if Ctrl-C is not pressed within a few seconds. If Ctrl-C is pressed, you
will be presented with two options:
Bypass loading from I/O slots.
Bypass loading from I/O slots and core I/O.
The Bypass loading from I/O slots and core I/O option may be useful if a bad core I/O
UEFI driver is preventing system boot. USB drives can still be used at the UEFI shell to
update core I/O drivers.
CAUTION:
feature, be sure wait for the prompt before hitting Ctrl-C.
NOTE:
when Ctrl-C can be pressed is very short. For typical boots, HP recommends that you let
the prompt time out.
After selecting an option, boot will proceed.
NOTE:
4. Depending on how the server blade was configured from the factory, and if the OS is installed
at the time of purchase, you are taken to:
UEFI shell prompt
OS login prompt
If the server blade has a factory-installed OS, you can interrupt the boot process to configure
your specific UEFI parameters.
If you are at the UEFI shell prompt, go to
If you are at the OS login prompt, go to
26 Installing the server blade into the enclosure
Terminal windows should be set to a window size of 80 columns x 25 rows for
Hitting Ctrl-C before the prompt will not work and may even disable this
It can take several minutes for this prompt to appear, and the window of time
If no option is selected, normal boot will proceed after ten seconds.
"UEFI Front Page" (page
"OS login prompt" (page
27).
29).