Table of Contents
Advertisement
Configuration
Watching How the DVR Reacts to Motion
Turn Zone View On in the Motion Detection Settings screen to observe how the DVR
reacts to motion. When in the motion viewing mode, any detected motion within the
zone displays in red.
Adjusting the Motion Ignoring Interval
You can control excessive event logging and remote notification of motions detected
after the motion dwell time by adjusting the motion ignoring intervals.
1.
2.
Setting Up Sensitivity Levels for the Daytime Range
1.
2.
3.
Motion Detection Actions Tabs
Using the Actions 1 and Actions 2 tabs, you can set the DVR to react to motion detection
differently for each camera. Each camera can:
•
•
•
•
•
•
Document 800-03650 Rev D
02/09
Highlight the field beside Motion Ignoring Interval in the Motion Detection
Settings screen and press
Never appears.
Select a Motion Ignoring Interval from the list.
Now the DVR will not log and notify motion events that occurred during the preset
interval range.
Highlight the Daytime Setup field in the Motion Detection Settings screen and
press
to set up the Daytime range. The Daytime Setup Screen appears.
Figure 3-60
Daytime Setup Screen
Highlight the field beside Daytime and press
Use the UP and DOWN arrows to set the Daytime range.
The DVR considers the remaining time range as the Nighttime.
Be associated with another camera
Trigger an Alarm-Out connector
Sound the internal buzzer of the DVR
Notify a number of different devices
Move PTZ cameras to preset positions
And/or display a camera on a SPOT monitor
. A list of intervals ranging from 1 to 10 seconds to
.
87
Advertisement
Table of Contents
