Connecting The Video Source; Connecting The Loop Through Video; Figure 2-2 Video Input Connectors; Figure 2-3 Video Loop Through Connectors - Honeywell HRSD8 User Manual

Installation
Table 2-1
#
1
2
3
4
5
Your DVR can be used with either NTSC or PAL equipment.

Connecting the Video Source

Connect the coaxial cables from the video sources to the BNC Video In connectors.

Connecting the Loop Through Video

If you would like to connect your video source to another device, you can use the Loop
BNC connectors.
24
Rear Panel Connections
Connection
Video input
Looping connectors
Audio input x2; audio output x1
Video main: BNC or VGA;
Spot-BNC
Serial RS232C port
Note You cannot mix NTSC and PAL equipment. For example, you
cannot use a PAL camera and an NTSC monitor.
Figure 2-2 Video Input Connectors
Figure 2-3 Video Loop Through Connectors
Note The Loop BNC connectors are auto terminated. Do NOT connect
a cable to the Loop BNC unless it is connected to a terminated
device because it will cause poor quality video.
# Connection
6 Network/Ethernet port
7 RS485 port for remote devices
8 Alarm inputs
9 Alarm outputs
10 Power cord connector