Installing Top Mount Ice Machines - Follett 25 Installation, Operation And Service Manual

Installing top mount ice machines

(models C/E25CT400A/W, C/E50CT400A/W, C/E25HT400A/W, C/E50HT400A/W)
Dispensers with top mount ice machines cannot be mounted on legs. They must be bolted
!
to counter. Use gloves when lifting ice machine to protect hands from sheet metal edges.
1. On dispensers equipped with top mounted, water-cooled ice machines, feed condenser supply and drain lines from
back through utility knock-out (Fig. 4F) or through counter, as appropriate. Connect condenser supply line to inlet
fi tting (Fig. 3H) on utility fl ange at bottom of dispenser. Connect condenser drain line to outlet fi tting (Fig. 3J) on utility
fl ange at bottom of dispenser.
Note: Do not run condenser supply water through ice machine water fi lter system. Do not connect condenser drain
line to any other drain lines.
2. Remove dispenser top front cover by removing two screws at bottom corners of cover, lifting cover slightly and pulling
forward.
3. Remove ice machine compartment top and side panels.
4. Remove ice machine hold-down bracket from front of ice machine compartment.
5. Lift ice machine onto dispenser top and slide ice machine completely into position, compressor end fi rst. Front of ice
machine base must be fl ush with front of dispenser.
6. Reinstall hold-down bracket on front of ice machine with power cord and bin signal cords in notch. Do not cut or
pinch cords.
7. Insert loose end of ice transport tube through bracket on ice machine base into hopper access hole. Be sure that transport
tube is secured under retainer on fl oat reservoir bracket (Fig. 10, Step 2). Tighten transport tube clamp screw to secure ice
transport tube.
Fig. 10 – Ice transport tube
8. Connect plastic water supply line to fi tting at top of fl oat reservoir.
9. Connect vinyl drain from dispenser securely to 120° elbow on ice machine drain line.
10. Connect ice machine two-lead bin signal twist lock plug, and three-lead power connector, to dispenser twist-
connectors.
11. On dispensers equipped with water-cooled ice machines, connect condenser water supply and drain lines to
condenser fi ttings on ice machine.
12. Turn on water supply and check for leaks. Check that water level in fl oat reservoir (when full) is within 7mm (1/4") of
mark on side of reservoir, and that fl oat moves freely. Verify that water sensor tabs are immersed in water in reservoir.
Replace splash panel.
13. Install appropriate plug on power cord and insert into wall socket.
14. If dispenser is equipped with SensorSAFE remote protective plastic coating from dispense sensor labels.
15. Turn on power and bin signal rocker switches and test operation.
16. Clean and sanitize ice machine following instructions in ice machine manual.
17. Remove dispenser hopper access lid and clean and sanitize dispenser according to instructions on page 16.
18. Replace side and front covers and secure with screws. Installation is complete.
14
2
1
TIGHTEN
3 CLAMP
SCREW
25/50 Series 220 V 60 Hz/230 V 50 Hz Dispensers