Installing Countertop Dispensers - Follett 25 Installation, Operation And Service Manual

Installing countertop dispensers

1. Position dispenser in desired location, mark dispenser outline on counter and remove dispenser.
Dispensers with top mount ice machines cannot be mounted on legs. They must be bolted to counter.
!
Use gloves when lifting ice machine to protect hands from sheet metal edges.
2. Drill four 10mm (3/8") holes in counter
(Fig. 2) to anchor dispenser to counter.
Note: Follett countertop dispensers can have
any or all utilities run directly through counter or
out rear of dispenser. For dispensers with any
utilities exiting through counter, make counter
cut-out (Fig. 2)
3. If ice transport tube will exit out rear of
dispenser, remove ice transport tube knock-out
(Fig. 5G) from rear of dispenser.
Note: Utility connections can be accessed
through front of dispenser by removing stainless
steel splash panel,
or by removing access panel (Figs. 4, 5)
on back of dispenser.
4. If any electric utilities or water line will be
connected through rear of dispenser, remove
utility knock-out (Figs. 4, 5F) from rear of
dispenser and install supplied protective grommet.
5. If power is to be supplied through counter cut-out, complete steps 6-9. If power is to be supplied through
rear of dispenser, proceed to step 10.
Fig. 3 – Top view, dispenser plumbing connections countertop
drain pan
25/50 Series 220 V 60 Hz/230 V 50 Hz Dispensers
Fig. 2 – Counter cut-out, all models
534mm (21")
512mm (20.125")
13mm
(.5")
cut-out
229mm x 356mm
10mm
(9" X 14")
holes
(.375")
10mm (.375")
DRAIN PAN
(L) 19mm (3/4") FPT dispenser drain
(K) alternate 19mm (3/4") dispenser
drain location
(G) 10mm (3/8") FPT water inlet
(J) 10mm (3/8") FPT condenser
water outlet
(H) 10mm (3/8") FPT condenser
water inlet
12mm (.44")
267mm
(10.5")
318mm
(12.5")
420mm
(16.5")
166mm
(6.5")
39mm (1.5")
9