Follett 25 Installation, Operation And Service Manual page 12

8. Remove utility knock-out (Fig. 4, 5F) from rear of dispenser and install supplied protective grommet. For dispensers
using RIDE ice machines, remove ice transport tube knock-out (Fig. 5G) from rear of dispenser.
9. Run water supply line from back through utility knock-out (Fig. 5F) and connect water supply line to
3/8" FPT fi tting on utility fl ange at bottom of dispenser (Fig. 3G).
10. Connect and run a dedicated drain line from 3/4" drain tube to wall or fl oor drain. An air break should be provided.
11. Proceed with either RIDE or top-mounted ice machine connection instructions, as appropriate.
Fig. 7 – Mounting dimensions for wall mount
units without drain pan with RIDE ice machine
C/E25HR400A/W
C/E25HT400A/W
648mm
242mm (9.5")
(25.5")
C/E50HT400A/W
292mm (11.5")
C/E50HR400A/W
750mm
C/E25HT400A/W
(29.5")
241mm (9.5")
C/E50HT400A/W
292mm (11.5")
89mm (3.5")
121mm
(4.75")
access opening
cover
wall bracket: bottom view
12
407mm
(16")
wall stud
10mm (3/8") fasteners
wall bracket
utility
89mm (3.5")
cut-out
35mm
(1.375")
292mm
(11.5")
Fig. 8 – Mounting dimensions with wall mount units
without drain pan with integral ice machine
445mm
(17.8")
C/E25HR400A/W
C/E25HT400A/W
648mm
242mm (9.5")
(25.5")
C/E50HT400A/W
292mm (11.5")
C/E50HR400A/W
750mm
C/E25HT400A/W
(29.5")
241mm (9.5")
C/E50HT400A/W
292mm (11.5")
89mm (3.5")
121mm
(4.75")
wall bracket - bottom view
access opening
cover
25/50 Series 220 V 60 Hz/230 V 50 Hz Dispensers
530mm
(20.875")
filler strip
407mm
(16")
wall stud
10mm (3/8") fasteners
wall bracket
utility
89mm (3.5")
cut-out
35mm
(1.375")
292mm
(11.5")