Installing Top Mount Icemakers - Follett Symphony 25CT400A Installation, Operation And Service Manual

Installing top mount icemakers

Models 25CT400A/W, 50CT400A/W, 25HT400A/W, 50HT400A/W
Dispensers with top mount icemakers cannot be mounted on legs. They must be bolted to counter.
!
Use gloves when lifting icemaker to protect hands from sheet metal edges.
1. On dispensers equipped with top-mounted, water-cooled icemakers, feed condenser supply and drain lines from
back through utility knock-out (Fig. 4F) or through counter, as appropriate. Connect condenser supply line to inlet
fi tting (Fig. 3H) on utility fl ange at bottom of dispenser. Connect condenser drain line to outlet fi tting (Fig. 3J) on utility
fl ange at bottom of dispenser.
Note: Do not run condenser supply water through icemaker water fi lter system. Do not connect condenser drain line
to any other drain lines.
2. Remove dispenser top front cover by removing two screws at bottom corners of cover, lifting cover slightly and pulling
forward.
3. Remove icemaker compartment top and side panels.
4. Remove icemaker hold-down bracket from front of icemaker compartment.
5. Lift icemaker onto dispenser top and slide icemaker completely into position, compressor end fi rst. Front of icemaker
base must be fl ush with front of dispenser.
6. Reinstall hold down bracket on front of icemaker with power cord and bin signal cords in notch. Do not cut or pinch
cords.
7. Insert loose end of ice transport tube through bracket on icemaker base into hopper access hole. Be sure that transport
tube is secured under retainer on fl oat reservoir bracket (Step 2, Fig. 10). Tighten transport tube clamp screw to secure ice
transport tube.
Fig. 10 – Ice transport tube
8. Connect plastic water supply line to fi tting at top of fl oat reservoir.
9. Connect vinyl drain from dispenser securely to 120˚ elbow on icemaker drain line.
10. Connect icemaker two-lead bin signal twist lock plug, and three-lead power twist-lock plug, to dispenser twist-lock
connectors.
11. On dispensers equipped with water-cooled icemakers, connect condenser water supply and drain lines to condenser
fi ttings on icemaker.
12. Turn on water supply and check for leaks. Check that water level in fl oat reservoir (when full) is within 1/4" (6mm)
of mark on side of reservoir, and that fl oat moves freely. Verify that water sensor tabs are immersed in water in
reservoir. Replace splash panel.
13. Plug dispenser power cord into 20 amp rated NEMA 5-20 wall socket.
14. If dispenser is equipped with SensorSAFE remote protective plastic coating from dispense sensor labels.
15. Turn on power and bin signal rocker switches and test operation.
16. Clean and sanitize icemaker following instructions in icemaker manual.
17. Remove dispenser hopper access lid and clean and sanitize dispenser according to instructions on page 16.
18. Replace front cover and secure with screws. Installation is complete.
2
1
TIGHTEN
3
CLAMP
SCREW
14