Show Errdisable Recovery - Cisco Catalyst 3750 Command Reference Manual

show errdisable recovery

show errdisable recovery
Use the show errdisable recovery user EXEC command to display the error-disable recovery timer
information.
Syntax Description | begin
| exclude
| include
expression
Command Modes User EXEC
Command History Release
12.1(11)AX
Usage Guidelines
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
are not displayed, but the lines that contain Output are displayed.
A gbic-invalid error-disable reason refers to an invalid small form-factor pluggable (SFP) interface.
Examples
This is an example of output from the show errdisable recovery command:
Switch> show errdisable recovery
ErrDisable Reason
-----------------
udld
bpduguard
security-violatio
channel-misconfig
vmps
pagp-flap
dtp-flap
link-flap
gbic-invalid
psecure-violation
gbic-invalid
dhcp-rate-limit
unicast-flood
loopback
Timer interval:300 seconds
Interfaces that will be enabled at the next timeout:
Interface
---------
Gi1/0/2
Catalyst 3750 Switch Command Reference
2-282
show errdisable recovery [ | {begin | exclude | include} expression]
(Optional) Display begins with the line that matches the expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
Timer Status
--------------
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Errdisable reason
-----------------
link-flap
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
Time left(sec)
--------------
279
78-16181-01