Dot1X Timeout - Cisco Catalyst 3750 Command Reference Manual

Chapter 2 Catalyst 3750 Switch Cisco IOS Commands

dot1x timeout

Use the dot1x timeout interface configuration command on the switch stack or on a standalone switch
to set 802.1x timers. Use the no form of this command to return to the default setting.
Syntax Description
quiet-period seconds
reauth-period seconds
server-timeout seconds
supp-timeout seconds
tx-period seconds
Defaults These are the default settings:
reauth-period is 3600 seconds.
quiet-period is 60 seconds.
tx-period is 30 seconds.
supp-timeout is 30 seconds.
server-timeout is 30 seconds.
Command Modes Interface configuration
Command History Release
12.1(11)AX
12.1(14)EA1
12.2(18)SE
78-16181-01
dot1x timeout {quiet-period seconds | reauth-period seconds | server-timeout seconds |
supp-timeout seconds | tx-period seconds}
no dot1x timeout {quiet-period | reauth-period | server-timeout | supp-timeout | tx-period}
Number of seconds that the switch remains in the quiet state following a
failed authentication exchange with the client. The range is 1 to 65535.
Number of seconds between re-authentication attempts. The range is 1 to
65535.
Number of seconds that the switch waits for the retransmission of packets
by the switch to the authentication server. The range is 30 to 65535.
Number of seconds that the switch waits for the retransmission of packets
by the switch to the 802.1x client. The range is 30 to 65535.
Number of seconds that the switch waits for a response to an
EAP-request/identity frame from the client before retransmitting the
request. The range is 15 to 65535.
Modification
This command was introduced.
The supp-timeout and server-timeout keywords were added, and the
command was changed to the interface configuration mode.
The ranges for the server-timeout, supp-timeout, and tx-period keywords
were changed.
Catalyst 3750 Switch Command Reference
dot1x timeout
2-83