Reload - Cisco Catalyst 3750 Command Reference Manual

Chapter 2 Catalyst 3750 Switch Cisco IOS Commands

reload

Use the reload privileged EXEC command to reset the stack member and applies a configuration change
into effect.
Syntax Description LINE
at
cancel
in
slot stack-member-number
standby-cpu
Defaults
Immediately resets the stack member and puts a configuration change into effect.
Command Modes Privilege EXEC
Command History Release
12.1(11)AX
Examples This example shows how to reload the switch stack:
Switch(config)# reload
System configuration has been modified. Save? [yes/no]: y
Proceed to reload the whole Stack? [confirm] y
This example shows how to reload a specific stack member:
Switch(config)# reload slot 6
Proceed with reload? [confirm]y
Related Commands Command
reload
switch priority
switch renumber
show switch
78-16181-01
reload [LINE | at | cancel | in | slot stack-member-number | standby-cpu]
Modification
This command was introduced.
Description
Accesses a specific stack member.
Changes the stack member priority value.
Changes the stack member number.
Displays information about the switch stack and its stack members.
Specify the reason for the reload.
Specify the time in hh:mm for the reload to occur.
Cancel the pending reload.
Specify a time interval in mmm or hhh:mm for reloads to occur.
Save the changes on the specified stack member and restart it.
Reload the standby route processor (RP).
Catalyst 3750 Switch Command Reference
reload
2-221