Cisco Catalyst 3750 Command Reference Manual page 634

debug platform ip igmp snooping
rpc [cfg | l3mm | misc
| vlan]
warn
Defaults
Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.1(11)AX
Usage Guidelines The undebug platform ip igmp snooping command is the same as the no debug platform ip igmp
snooping command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you must start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member.
Related Commands Command
debug ip igmp
snooping
show debugging
Catalyst 3750 Switch Command Reference
B-34
Display IGMP snooping remote procedure call (RPC) event debug messages.
The keywords have these meanings:
cfg—(Optional) Display IGMP snooping RPC debug messages.
•
l3mm—(Optional) IGMP snooping Layer 3 multicast router group RPC
•
debug messages.
misc—(Optional) IGMP snooping miscellaneous RPC debug messages.
•
vlan—(Optional) IGMP snooping VLAN assert RPC debug messages.
•
Display IGMP snooping warning messages.
Modification
This command was introduced.
Description
Displays information about platform-independent IGMP snooping activity.
Displays information about the types of debugging that are enabled. For
syntax information, select Cisco IOS Release 12.2 Configuration Guides
and Command References > Cisco IOS Configuration Fundamentals
Configuration Guide, Release 12.2 > System Management >
Troubleshooting and Fault Management.
Appendix B Catalyst 3750 Switch Debug Commands
78-16181-01