Table of Contents
Advertisement
4.3.1 CONFIG - WAN Setup
WAN Setup: The WAN configuration page allows you to set the configuration for the WAN/ADSL ports.
ADSL connections can be configured in a variety of ways depending on the ISP/WAN configuration, and the
requirements of your home or office LAN. This 4 Ports 11g ADSL2/2+ Router supports the following ADSL
connection types:
PPPoE (RFC2516)
PPPoA (RFC2364)
DHCP
Static
Bridged (RFC1483)
CLIP (RFC1577)
Configuring the 4 Ports 11g ADSL2/2+ Router to match these connection types may require entry of some or
all of the following values:
ISP Account Username and Password
VPI/VCI Setting
Encapsulation Type/Multiplexing ( Either LLC or VC, check with your ISP for details )
ADSL Handshaking Mode ( Default setting is MMODE )
Network Settings for Bridged Mode operation:
For PPPoA or PPPoE users, you need the following values from your ISP:
Username
Password
For Bridged Mode connections (RFC1483), you need the following information from your ISP:
DSL Fixed Internet IP address
Subnet Mask
Default Gateway IP Address
Primary DNS IP address.
The next sections will describe in detail how to set up each of these connection types and save them as
Connection Profiles.
4 Ports 11g Wireless ADSL2/2+ Router
35
Advertisement
Table of Contents
