Table of Contents
Advertisement
4.6.4 TOOLS - Update Gateway
Update Gateway: Firmware is the software that controls the 4 Ports 11g Wireless ADSL2/2+ Router and also
provides the user interface that is subject of this manual. The Firmware resides in the 4 Ports 11g Wireless
ADSL2/2+ Router internal Flash memory; currently loaded firmware version can be found under STATUS
Product Information.
Note: It is recommends that you back up your configuration before doing a firmware upgrade. After the
upgrade is complete, you may need to restore your configuration settings.
To access Firmware Updates, click on TOOLS
pop-up.
Select a File: Click on the Browse... button to locate the Firmware or update image file from your
computer's hard drive.
Update Gateway: Click the Update Gateway button to upgrade your 4 Ports 11g Wireless
ADSL2/2+ Router. The system will be restarted automatically after the Firmware/Image is
successfully uploaded. You will need to reconnect again to configure your setup.
Get Configuration: You may download your configuration file from the system by clicking Get
Configuration. Follow the instruction and save your configuration file in your hard drive.
Note: When uploading Firmware/Configuration File to the 4 Ports 11g Wireless ADSL2/2+ Router, it is
important not to interrupt the Web browser by closing the window, clicking a link, or loading a new page.
If the browser is interrupted, it may corrupt the upgrading process. When the upload is complete, your 4
Ports 11g Wireless ADSL2/2+ Router will automatically reboot and restart. The upgrade process will
typically take about 1~2 minutes.
Update Gateway. The following window screen will
4 Ports 11g Wireless ADSL2/2+ Router
141
Advertisement
Table of Contents
