Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Dynamix Tiger 2Plus
Summary of Contents for Dynamix Tiger 2Plus
-
Page 1: User Manual
Tiger 2Plus (4LAN) ADSL 2+ Router User Manual V 1.3... -
Page 2: Table Of Contents
Tiger 2Plus (4LAN) ADSL 2+ Router User Manual CONTENTS 1.OVERVIEW ............................3 1.1 ABOUT ADSL........................3 1.2 ABOUT ADSL2/2+.........................3 1.3 FEATURES ...........................3 2 SPECIFICATION ..........................4 2.1 I ......................4 NTERFACE NTRODUCTION 2.1.1 Indicator and Interface ....................4 2.1.2 Splitter Spec ........................5 2.2 HARDWARE CONNECTION ....................5 2.3 LED S... -
Page 3: Overview
Tiger 2Plus (4LAN) ADSL 2+ Router User Manual 1.OVERVIEW 1.1 ABOUT ADSL An ADSL MODEM is a broadband Internet access device, which utilizes the high frequency segment of the phone line to transmit high-speed data without affecting the voice transmission. The frequency of the ADSL signal is higher than that of voice, so voice and ADSL signal can coexist in one line by using a splitter to insulate each from the other. -
Page 4: Specification
Tiger 2Plus (4LAN) ADSL 2+ Router User Manual 2 SPECIFICATION 2.1 INTERFACE INTRODUCTION 2.1.1 INDICATOR AND INTERFACE Table 2.1 ITEM Name State introduction POWER A steady red light means the power connection works properly Yellow, shows DSL line status. Indicator... -
Page 5: Splitter Spec
Tiger 2Plus (4LAN) ADSL 2+ Router User Manual 2.1.2 SPLITTER SPEC Table 2.2 Interface Introduction LINE Connected with telephone line Connect with the LINE port of ADSL ADSL Modem using telephone line provided. PHONE Connect with telephone 2.2 HARDWARE CONNECTION... -
Page 6: Configuration
Tiger 2Plus (4LAN) ADSL 2+ Router User Manual 3.CONFIGURATION 3.1 DEFAULT CONFIGURATION ADSL MODEM has pre-configured with the VCI/VPI which is in common use. The default dial-up mode is bridge encapsulation. For bridge mode, no need to configure any more parameter. However, the third party dial-up software is needed for connection with the Internet 3.2 COMPUTER CONFIGURATION... -
Page 7: Save Setting
Tiger 2Plus (4LAN) ADSL 2+ Router User Manual 3.3.2 SAVE SETTING After getting through each page for parameters setting, click “Save” or “Save apply” to store the value in ADSL MODEM. Briefly, we named “Save”. Note When you save the settings, the web page will be refreshed slowly, please wait it finished. - Page 8 Tiger 2Plus (4LAN) ADSL 2+ Router User Manual Click on the next connection which you want modify. Press “Edit” button, enter the configure guide, as Figure 3.3 Figure 3.3 The value for VPI/VCI is assigned by your ISP. After inputting the PVC value, press “Next” into “connection type”.
-
Page 9: Rfc1483 Bridge Configuration
Tiger 2Plus (4LAN) ADSL 2+ Router User Manual The Modem supports five ADSL protocol modes. Choose the protocol which is appointed by ISP and PVC encapsulation, click “Next” enter to the protocol configure. Below, we introduce the configuraion of the five protocol modes. - Page 10 Tiger 2Plus (4LAN) ADSL 2+ Router User Manual Figure 3.6 Note When you use bridge mode, please close “DHCP SERVER”, the result as Figure 3.7 Figure 3.7 Page 10 Total 17 Pages...
-
Page 11: Pppoe Configuration
Tiger 2Plus (4LAN) ADSL 2+ Router User Manual 3.4.3 PPPOE CONFIGURATION PPPoE is also known as RFC 2516. It is a method of encapsulating PPP packets over Ethernet. PPPoA is also known as RFC2364 and named as Peer to Peer Protocol over ATM. As PPPoE, it also has all the features of PPP. -
Page 12: Static Address
Tiger 2Plus (4LAN) ADSL 2+ Router User Manual long the connection will be disconnected in the absence of traffic. If the value is 0, connection will not be disconnected. Press “Next step” when configuration is finished. The following operation is same with Figure 3.5. -
Page 13: Other Configuration
Tiger 2Plus (4LAN) ADSL 2+ Router User Manual 4 OTHER CONFIGURATION 4.1 LAN CONFIGURATION Configuration of Modem’s IP address and password 4.1.1 CONFIGURATION OF MODEM’S IP ADDRESS As a network device, ADSL Modem has its own IP address and MAC address. The factory sets the MODEM, at a default IP address of 192.168.1.1 and subnet mask of 255.255.255.0. -
Page 14: Password Configuration
Tiger 2Plus (4LAN) ADSL 2+ Router User Manual • Define the “Start IP address” and the “End IP address” of DHCP server (for example, from 192.168.1.2 to 192.168.1.254). • Input the value of lease (Measured by the second, 0 indicates permanently valid). -
Page 15: Troubleshooting
Tiger 2Plus (4LAN) ADSL 2+ Router User Manual 5. TROUBLESHOOTING 5.1 UNABLE TO ACCESS INTERNET 5.1.1 CHECK THE LINE AND THE DEVICE Check the indicator of power supply is on, if not, Make sure the connection of power supply is correct;... - Page 16 Tiger 2Plus (4LAN) ADSL 2+ Router User Manual Note 1 The precondition is that LAN settings in the modem has not been modified. Note 2 We usually start command line mode in Windows 2000 as follows: click on the “RUN” item of Windows Start Menu, input characters “cmd”...
-
Page 17: Annex Shipping List
Tiger 2Plus (4LAN) ADSL 2+ Router User Manual ANNEX SHIPPING LIST ADSL MODEM ×1 Splitter ×1 User Manual ×1 Power Supply ×1 Cable Cat5 RJ45 ×1 Telephone Line ×2 Warranty Certificate ×1 Page 17 Total 17 Pages...
Need help?
Do you have a question about the Tiger 2Plus and is the answer not in the manual?
Questions and answers