Drive Frame Unit Assy - Brother DCP-9045CDN Service Manual

8.43 Drive Frame Unit ASSY

(1) Remove the three bind B M4x12 Taptite screws, and then remove the Drive frame unit
ASSY from the Frame unit.
(2) Disconnect the Connector from the Drive frame unit ASSY.
Connector
Taptite, bind B M4x12
(Tightening torque:
1.20 ±0.1 N m)
*1
Drive frame unit ASSY
Taptite, bind B M4x12
(Tightening torque: 1.20 ±0.1 N m)
*1
Tightening Note:
When tightening the screw, slowly turn it counterclockwise (in the direction to loosen the
screw) with your hand until you feel that the screw is a little dropped in the hole. Then,
slightly turn it clockwise (in the direction to tighten the screw) with your hand and tighten it
according to the specified torque with a screwdriver.
Frame unit
Drive frame unit ASSY
*1
Fig. 3-242
3-167
<Left side>
Confidential