Brother DCP-9045CDN Service Manual page 465

< WSW45 >
Selector No.
1
Delay time from when
|
documents are set until the
ADF starts drawing them in
3
Periodical correction intervals of
4
the reference voltage to be
|
applied to white level
compensation for document
6
scanning, during standby
Standby position of the CCD
7
unit
Line polarity reverse detection
8
function
Note:
WSW45 is applicable only to flat head-type models.
- Selectors 1 through 3: Delay time from when documents are set until the ADF starts
These selectors determine how long the ADF will delay automatic drawing-in of documents
(to the scanning standby position) after you set them in the ADF, as well as determining
whether or not the ADF automatically draws in documents.
- Selectors 4 through 6: Periodical correction intervals of the reference voltage applied to
These selectors set the correction intervals (in seconds) of the reference voltage to be
applied to white level compensation for document scanning during standby, as well as
determining whether or not the controller makes the reference voltage correction during
standby. (Conventionally, the correction has been made immediately before the start of
actual scanning)
This function takes effect in copying. Making the correction during standby may shorten
the preparation time for copying.
Note:
Do not access these selectors.
Function
drawing them in
white level compensation for document scanning, during standby
App. 1-50
Setting and Specifications
No. 1 2 3
0 0 0: No automatic drawing-in
0 0 1: 1 sec.
0 1 0: 2 sec.
0 1 1: 3 sec.
1 0 0: 4 sec.
1 0 1: 5 sec.
1 1 0: 6 sec.
1 1 1: 7 sec.
No. 4 5 6
0 0 0: No correction of reference
voltage during standby
0 0 1: 10 sec.
0 1 0: 30 sec.
0 1 1: 1 min.
1 0 0: 3 min.
1 0 1: 5 min.
1 1 0: 10 min.
1 1 1: 30 min.
0: CCD home position
1: Location of the white-level reference
film
0: No 1: Yes
Confidential