Brother DCP-9045CDN Service Manual page 267

Assembling Note:
When assembling the Paper feed frame unit, make sure to follow the procedure described
below.
(1) Put the belt cleaner release sensor harness and belt cleaner release solenoid harness
through the hole on the paper feed frame.
(2) Put the two harnesses above and T1 PE/edge sensor harness through the PF CR harness
holder and put them out of the hole on the Side frame L.
(3) Hold the PU lift up cam with a Screwdriver or similar and push to the back of the machine .
The section "B" shown in
operation, which makes it easy to assemble the lift arm.
Side frame L
Fig. 3-183 in the next page can be moved up and down by this
PU lift up cam
Screwdriver
Fig. 3-181
3-134
<Front>
Confidential