Setting The Number Of Dot Increments - Intermec 3400 User Manual

Configuration DIP Switch Settings

Setting the Number of Dot Increments

You can move the label rest point and X forms adjust configuration commands
forward or backward by setting the printer DIP switches. Use the top bank of
DIP switches to determine whether the movement is forward or backward. Use
the bottom bank of DIP switches to set the number of dot increments for label
rest point, X forms adjust, and Y forms adjust. The printer moves in 5 mil
increments or 0.005 inch per dot.
If the printer is in 2.5 mil Advanced mode (3440 printer only) it moves 0.0025
inch per dot.
Note: The next table only shows the settings for the bottom bank of switches, see the
Configuration DIP Switch Settings table for the top bank DIP switch settings.
NugFont
HelvC
OFF
O = OFF
1 = ON
ON
Label Rest Point
Adjust Forward
Adjust Backward
86XX Emulation
Advance Mode
10 Mil
15 Mil
X Forms Adjust
Adjust Forward
Adjust Backward
Y Forms Adjust
N: Number. Least significant bit first.
C o d e 39
Using Test and Service Mode
Top Bank
1 2 3 4 5 6 7 8
O 1 1
O
1
1 O 1
O O
1 O
1 1
1 1 1 1
O
1
O
1 1 1
Bottom Bank
1 2 3 4 5 6 7 8
N N N N N
N N N N N
N N N N N
N N N N N
N N N N N
3XXXU.046
6
6-9