Intermec 3400 User Manual page 41

Loading Media for Self-Strip Printing
5. Unscrew the edge guide and slide it to the outer edge of the lower media
6. Pull down on the lower media guide to allow easy access to the media path.
7. Unroll several inches of media, insert it between the upper media guide and
8. Release the lower media guide and adjust the edge guide to position the
9. Pull out 10 to 12 inches of media and remove the exposed labels from the
10. Open the media access door and thread the media liner under the self-strip
11. Remove the clasp from the rewinder hub and wind approximately 2 inches
NugFont
HelvC
I n t e
r m e
c
3 4
4 0
Media
liner
Media
access door
Self-strip
assist roller
guide. Screw it in place.
Note: If you are replacing the empty media roll with a new roll of the same width,
you do not need to adjust the edge guide.
the lower media guide, and out the front of the printer.
media firmly against the inside wall of the printer.
media liner.
assist roller and over the rewinder hub in a clockwise direction.
of media liner clockwise over the rewinder hub.
C o d e 39
Operating the Printer
Lower media
guide
Edge
guide
Rewinder
Head lift
hub
Rewinder
lever
clasp
2
Media roll
Supply roll
retainer
Supply roll
post
Media
support
Upper
media
guide
3XXXU.027
2-9