Intermec 3400 User Manual page 96

3400, 3440, and 3600 Bar Code Label Printer User's Manual
To adjust the label rest point
1. Turn the On/Off switch to the off position.
2. Press and hold the Feed/Pause button while turning on the printer.
3. In the top bank of the Test and Service DIP switches, turn off switch 1 and
4. In the bottom bank of the Test and Service DIP switches, turn on or off the
5. Press the Feed/Pause button.
6. Verify that the label rest point number on the software configuration label
7. Try printing again to see if you need to readjust the DIP switches in the
8. If you need to readjust the DIP switches in the Bottom Bank, repeat Steps 4
6-12
The printer prints the hardware configuration test label and then enters
Data Line Print mode.
turn on switches 2 and 3.
To adjust the label rest point forward (feed more label), turn off DIP
switch 4.
To adjust the label rest point backward (retract label), turn on DIP switch 4.
Top Bank
OFF
ON
1 2 3 4
Switch settings
for feeding
label forward
appropriate DIP switches. See the Dot Increments DIP Switch Settings table
on page 6-10.
The printer prints the software configuration label and stops at the new
location.
matches the number you set in Step 4.
bottom bank.
through 7. If not, exit Test and Service mode by turning off the printer and
returning all DIP switches to their original settings.
NugFont
HelvC
Top Bank
OFF
ON
1 2 3 4
Switch settings
for retracting label
C o d e 39
3XXXU.48