Installation Of Swing Axle - Husqvarna Rider Pro 15 Workshop Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
Reparation instructions

Installation of swing axle

1
• Grease half of the axle (the half that has not
been turned down) and press it from the back
into the steering spindle (see diagram).
• Attach the washer and circlip on the swing axle's
inner holder.
• Fix the dust guard (with a thin lip behind) approx.
2/3 of the way in on the axle and lubricate the
axle on both sides of the dust guard.
2
Roll the rear frame forwards and press it in on the
swing axle.
34
– Svenska
www.mymowerparts.com
3
5
3
• Attach a washer and circlip onto the swing axle
(1).
• Fit the wire to the differential lock on ProFlex 21,
see "Removing/ replacing hydrostatic transmis-
sion".
• Connect the brake wire (2) to the brake arm.
Tighten the brake wire nuts.
• Fit the linkage for the throttle control (3). Fix the
wire on the underside of the axle.
• Fit the drive belt over the pulley and attach the
spring to the tensioning roller (4).
4
• Check that the controls and wires are correctly
adjusted (see "Checking and adjusting brake
wire", "Checking and adjusting speed control
wire" and "Checking and adjusting differential
lock".
• Check and adjust the neutral position switch if
necessary.
• Fit the fan.
• Finally, fit the transmission cover.
1
4
2