Installation Of Swing Axle - Husqvarna Rider 13 Workshop Manual

Reparation instructions

Installation of swing axle

1
• Grease half of the axle (the half that has not
been turned down) and press it from the back
into the steering spindle (see diagram).
• Attach the washer and circlip on the swing axle's
inner holder.
• Fix the dust guard (with a thin lip behind) approx.
2/3 of the way in on the axle and lubricate the
axle on both sides of the dust guard.
2
Roll the rear frame forwards and press it in on the
swing axle.
36
– English
3 Rider 11
• Attach a washer and circlip onto the swing axle
(1).
• Firmly secure the wires' holder plates (2), as well
as the gear and brake wires (3 and 4).
• Connect the belt onto the pulley and tightly screw
the tensioning wheel arm (5) onto the rear frame.
• Attach the clutch wire (6) and the tensioning
wheel spring (7).
3 Rider 13 and 16
• Fit the washer and circlip on the swing axle.
• Fit the hydrostatic transmission wire and its
casing (2+4).
• Fit the cable on the neutral position contact (5).
• Fit the rear belt (8).
• Fit the brake wire on the arm under the tank and
the casing's holder on the rear frame (6).
• Fit the tensioning wheel spring (1).
• Fit the hydrostatic transmission's fan and the
circlip (7).
4 . Check that wires and controls are correctly
adjusted (see Inspection and adjusting of
respective wires). Finally, fit the cover on the
transmission/gearbox.
Check the setting of the neutral position switch
on machines with hydrostatic transmission, see
"Electrical system\Microswitch neutral position".