For Husqvarna Parts Call 606-678-9623 or 606-561-4983
Reparation instructions
Checking and adjusting mower deck
parallelism
1
Place the ride-on mower on an even surface and
measure the distance between the ground and the
edge of the deck, at the front and rear of the cover.
The cutting unit should slope forwards slightly so
that the rear edge is 2-4 mm higher than the front
edge.
2 Adjusting
The diagram shows Rider Pro 15, on ProFlex the
mowing deck is suspended in the deck frame.
• Remove the front cover and the right-hand
fender.
• Undo the nuts on the lift strut.
• Unscrew the strut (anticlockwise) to lower the
rear edge of the hood.
Screw the strut in (clockwise) to raise the rear
edge of the hood.
• Tighten the nuts after adjustment.
• On completion of the adjustment the unit's
parallelism should be re-checked.
• Fit the right-hand fender and the front hood.
48
– Svenska
www.mymowerparts.com
Adjusting cutting height area
1
Remove the plastic cover on the right side of
ProFlex. Rider Pro 15 is adjusted by carefully
bending away the plate.
2
Raise or lower the entire mowing deck by screwing
the nuts up or down.
If the highest cutting height is raised by 5 mm the
other fixed cutting heights will also be raised by the
same amount.