Transmission Maintenance; Oil Change - Husqvarna Rider Pro 15 Workshop Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983

Transmission maintenance

Oil change

Most garden owners do not have tools for or
experience of changing transmission oil. The
transmission probably has a longer operational life
than other ride-on mower components, this makes
transmission oil changes less important for most
customers. However, the transmission's operational
life is increased if oil changes are made.
If the Rider is used professionally it is
recommended that the engine oil is replaced after
the first 50 hours in service and then every 500
hours or at least once a year.
IMPORTANT INFORMATION
Spent engine oil is hazardous to health
and must not be poured out on the
ground or in the nature, but should be
handed in to a designated place for
recycling.
Avoid skin contact and wash any spillage
with soap and water.
K62
Transmission holds 2,5 litres (SAE10W/30 engine
oil, class CD–SF).
• Empty the hydrostatic transmission with the two
plugs, width across flats 14 mm. The other
screws have smaller widths.
• Disconnect the hose that runs to the transmission
oil tank.
• Release the hexagonal socket head plug for the
filler hole at the front on the top of the transmis-
sion.
www.mymowerparts.com
K66
Transmission holds 2,5 litres (SAE10W/30 engine
oil, class CD–SF).
• Remove the plug from the drain hole.
• Disconnect the hose that runs to the transmission
oil tank.
• Release the hexagonal socket head plug for the
filler hole at the front on the top of the transmis-
sion.
K66, drain hole. The filter must be replaced when
the oil is changed.
K62 / K66, filler hole
Replace the drain plugs. Fill with oil through the
filler hole. Replace the hose and fill the oil tank.
Bleed the hydrostatic transmission as shown in
"Bleeding the hydrostatic transmission's oil system".
Test run the machine and top up with oil to the
correct level in the oil tank.
Reparation instructions
45
Svenska –