Replacing Steering Wires; Removal/Installation Of Steering Axle - Husqvarna Rider Pro 15 Workshop Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983

Replacing steering wires

1. Release the steering wires' rear attachment (1).
2. Release the steering wires' front attachment (2)
at the steering transmission chain (6) and pull
the steering wires out throught the frame.
Note. If the old wires are still complete, the new
wires can be attached to the old ones when
they are pulled out through the frame, the
new wires will then come automatically into
place.
3. Attach the new wires. Once the new wires are
in place, check the wire tension (see "Checking
and adjusting steering wires").

Removal/installation of steering axle

1. Release the steering wires' rear attachment (1).
Remove the frame plate.
2. Remove the steering wheel and steering
column by releasing the lock nut and
unscrewing the locking screw, lift the steering
wheel and steering column upwards.
3. Remove the two steering wheel rod carriers (2).
www.mymowerparts.com
4. Unscrew the bolt (5) from the bottom end of the
steering column.
5. Pull the steering axle (6) upwards and move the
lower part of the axle backwards to remove the
steering transmission chain (3).
6. Move the upper bearing (7) uppwards until it
goes free from the steering axle (6). If the
bearing is to be replaced, the bushing (8) must
be knocked out of the bearing.
7. Slide the bearing (9) off the bottom end.
8. Take the steering axle out (6) downwards.
9. To assemble the steering axle, the reverse
order is applied. For assembly purposes, the
two steering wheel rod carriers (4), are tighte-
ned with moment (5–10 Nm).
Reparation instructions
27
Svenska –