Replacing Articulated Steering Bearing - Husqvarna Rider Pro 15 Workshop Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983

Replacing articulated steering bearing

1
• Remove the engine according to the earlier
description (see "Removing engine").
• Block up the ride-on mower in front of the articulated
steering.
• Work off the drive belts.
• Release the oil tank for the transmission and move it
to one side to get at the brake wire.
2
4
2
• Release the tensioning wheel spring (1).
• Remove the locking spring and release the
locking spring on the linkage for throttle controll,
on the underside, and release the wire from the
underside of the axle (2).
• Release the brake wire spring and nuts. Prise the
wire off the brake arm (3).
• Remove the cable from the neutral position switch (4).
• Release the wire to the differential lock on ProFlex 21,
see "Removing/replacing hydrostatic transmission".
1
3
www.mymowerparts.com
3
• Loosen the steering wires (1) and remove the
steering rim.
• Remove the pulley (2). Move the lower part
forwards, the upper part backwards and detach
the pulley.
4
WARNING!
The articulation spring is strongly
tensioned and can cause injury if
it flies off. Wear safety glasses
and gloves when removing/
attaching the spring.
Detach the articulation spring. This spring is
strongly tensioned and should be secured with tool
no. 506 89 93-01 before the nut is removed.
Reparation instructions
31
Svenska –