Husqvarna Rider Pro 15 Workshop Manual page 42

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
3
Press the wire casing in the front holder in the
middle bracket.
4
Screw tight the hydrostatic transmission wire's
clamp. Press the linkage in its holder and fit the
lock spring.
5
Screw tight the linkage on the rear part of the
hydrostatic transmission wire. Screw 10-12 turns so
that the linkage is the right length.
www.mymowerparts.com
6
Draw the transmission wire along with the other
cabling. Place the wire at the bottom in the clamp,
under the articulated steering's bearing.
7
Place the hydrostatic transmission wire in position
and screw tight with the rear clamp under the left
drive shaft.
8
Adjust the wire as directed in "Inspection and
adjustment of speed regulator". Connect the rear
linkage and fit the lock spring. Tighten the rear lock
nut for the linkage.
9
Check the setting of the neutral position contact.
Reparation instructions
41
Svenska –