Changing Engine Oil; Checking And Adjusting Steering Wires - Husqvarna Rider Pro 15 Workshop Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
Reparation instructions
Changing the oil
The engine oil should be replaced after the first five
hours of running time, see service chart. Thereafter
it should be replaced every 100 hours of running
time.
WARNING!
Engine oil can be very hot if it is
drained off directly after the engine
is stopped. Therefore allow the
engine to cool down first.
IMPORTANT INFORMATION
Spent engine oil is hazardous to health and
must not be poured out on the ground or in
the nature, but should be handed in to a
designated place for recycling.
Avoid skin contact and wash any spillage
with soap and water.
Place a container under the drain plug on the left
side of the engine.
Remove the dipstick and drain plug. Let the oil
drain into the container.
Refit the drain plug and tighten it.
Fill with oil up to the "FULL" mark on the dipstick.
The dipstick should not be screwed down when
checking.
Pour the oil into the same hole the dipstick goes in.
Use engine oil SAE 30 or SAE 10W-30 alternatively
10W-40 grade SC-SH (above 0 C / +32 F). Above
+ 20 C / +68 F, SAE 40 can be used. Below 0 C /
+32 F, SAE 5W-20 should be used. The engine
takes 1.5 litres of oil excluding filter (1.7 litres
including filter).
Run the engine until warm, then check that there
are no oil leaks from the drain plug.
26
– Svenska
www.mymowerparts.com

Checking and adjusting steering wires

1
Remove the frame plate by releasing the screws
(two on either side).
2
The tension is checked by squeezing together the
wires (as shown in the diagram). Without having to
apply too much force, the wires should be able to
be squeezed to half the distance between them.
3
Stretch the wires by tightening the adjuster nuts
(one wire on each side of the ride-on mower). Do
not overtension them, they should only be tightened
up to the steering rim. Stretch both wires equally so
that the steering wheel position is not changed.
Check the wire tension after adjustments have
been made, in accordance with point 2.