Husqvarna Rider Pro 15 Workshop Manual page 10

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
Maintenance
Lubricate the parking brake wire
Lubricate throttle control
Lubricate choke control
Lubricate steering chain inside frame
tunnel
Check steering wires inside frame
tunnel
Clean engine cooling air intake
Clean the air filter's pre-filter (Oil-foam)
Change engine oil 1)
Clean the air filter's cartridge
Check/adjust cutting height setting
Check/adjust parking brake
Inspect flame guard/spark arrestor
(optional equipment)
Change the engine's oil filter
(every 200 hours).
Clean/replace spark plugs
Replace fuel filter in pipe
Clean pulse-air filter
Clean the cooling fins
Check engine valve clearance
Check whether oil change
4-5)
change are necessary for gearbox
(every 500 hrs)
Replace the air filter's pre-filter (Oil-foam)
Replace the air filter (paper filter)
(every 200 hours)
Carry out 300 hour service
1)
First change after 8 hours. When driving with a heavy load or when the ambient temperature is high, replace every 50 hours.
and replace the filter more often in dusty conditions.
4)
Conducted by authorised service workshop.
= Covered by this workshop manual.
= Not covered by this workshop manual.
= Described in the Operating Instructions.
WARNING!
No service procedures must be conducted on the engine or cutting unit unless:
• The engine is switched off.
• The ignition key is removed.
• The ignition cables are removed
from the plugs.
Page Daily main-
tenance
before after
-
-
-
-
26
-
-
26
2)
(paper filter) -
48
29
-
-
-
-
58
-
4) -
4)
or filter
45
2)
-
2)
-
4)
-
3)
For daily use of the machine lubrication should be conducted twice a week.
5)
ProFlex 21 only.
www.mymowerparts.com
Delivery and dealer service
Maintenance interval in
At least
3)
Weekly
hours
once a
main-
year
tenance
• The parking brake is applied.
• The cutting unit is disengaged.
25 50 100 300
2)
Clean
9
Svenska –