Adjusting Cutting Height Area; Adjusting Cutting Height - Husqvarna Rider 18 ProFlex Workshop Manual

Reparation instructions

Adjusting cutting height area

1
• Remove the plastic cover from the right-hand
side.
2
Raise or lower the entire mowing deck by screwing
the nuts up or down.
If the highest cutting height is raised by 5 mm the
other fixed cutting heights will also be raised by the
same amount.
48
– English

Adjusting cutting height

• Loosen the nuts on the height setting arm.
• Adjust so that the distance between the stop for
the lowest height setting and the protective
frame is 5 mm.
• Tighten the nuts.
• Check that the parallelism has not changed. If it
has changed, the parallelism must be
readjusted again.
• Check and adjust the cutting unit's ground
pressure as set out (see "Checking and
adjusting cutting unit ground pressure") if
necessary.
• Fit the nose.
NOTE!
The parallelism and height must be
adjusted again when changing the cutting
unit.