Adjusting cutting height area
1
3
11
1
• Remove the right-hand fender.
2
Raise or lower the entire mowing deck by screwing
the nuts up or down.
If the highest cutting height is raised by 5 mm the
other fixed cutting heights will also be raised by the
same amount.
Adjusting cutting height
2
•
Loosen the nuts on the height setting arm.
•
Adjust so that the distance between the stop for
the lowest height setting and the protective
frame is 5 mm.
•
Tighten the nuts.
•
Check that the parallelism has not changed. If it
has changed, the parallelism must be
readjusted again.
•
Check and adjust the cutting unit's ground
pressure as set out (see "Checking and
adjusting cutting unit ground pressure") if
necessary.
•
Fit the nose.
NOTE!
The parallelism and height must be
adjusted again when changing the cutting
unit.
Reparation instructions
47
English –