Watch Dog Reset (Jwd); Bmc Enable/Disable (Jpb1) - Supermicro X9SRW-F User Manual

Watch Dog Reset (JWD)

Watch Dog (JWD) is a system monitor that
can reboot the system when a software
application hangs. Close Pins 1-2 to reset
the system if an application hangs. Close
Pins 2-3 to generate a non-maskable inter-
rupt signal for the application that hangs.
See the table on the right for jumper set-
tings. Watch Dog must also be enabled in
the BIOS.

BMC Enable/Disable (JPB1)

JPB1 is used to enable or disable the
BMC (Baseboard Management Control)
chip and the onboard IPMI connection.
This jumper is used together with the IPMI
settings in the BIOS. See the table on the
right for jumper settings.
JPL1
J30
IPMI LAN
USB/0/1
A
USB/2/3 KB/MOUSE
JUSBKM
LE2
SXB2
A
3
C
JI2C3
JI2C2
T-SGPIO4 T-SGPIO3 T-SGPIO2
T-SGPIO1 JI2C1
J29
JTPM1:TPM/PORT80
JSTBY1:STAND BY POWER FOR DOM
JTPM1
LE1
JTPM1: TPM/PORT80
JBT1:CMOS CLEAR
+
B
SXB1B
2-29
Chapter 2: Installation
Watch Dog
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
Open
BMC IPMI Enable/Disable
Jumper Settings
Settings
Pins 1-2 Enabled (Default)
Pins 2-3 Disabled
A. Watch Dog Reset
B. BMC Enable
J1
J2
J3
J4
DIMM4B
DIMM4A
DIMM3B
DIMM3A
R136
C241
I-SATA3
I-SATA1 I-SATA5
I-SATA0
I-SATA2 I-SATA4 JWF1
1
Definition
Reset (default)
NMI
Disabled
Definition
DIMM1A
DIMM1B
DIMM2A
DIMM2B
1
JL1 :CHASSIS INTRUSION
FAN3