X9SCi-LN4/X9SCi-LN4F/X9SCA/X9SCA-F User's Manual
VGA Enable (JPG1)
JPG1 allows you to enable or disable
the onboard VGA connector. The default
position is on pins 1 and 2 to enable
VGA. See the table on the right for
jumper settings.
Watch Dog Enable (JWD)
Watch Dog (JWD) is a system moni-
tor that can reboot the system when a
software application hangs. Close Pins
1-2 to reset the system if an applica-
tion hangs. Close Pins 2-3 to generate
a non-maskable interrupt signal for the
application that hangs. See the table on
the right for jumper settings. Watch Dog
must also be enabled in the BIOS.
A
VGA Enable/Disable
Jumper Settings (JPG1)
Both Jumpers
Pins 1-2
Pins 2-3
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
Open
A. VGA Enable
B. Watch Dog Timer Enable
2-34
Definition
Enabled
Disabled
Watch Dog
Definition
Reset (default)
NMI
Disabled
B