Rear Unit Id Led (Le2); Ipmi Heartbeat Led (Bd1); Onboard Standby Power Led (Led2) - Supermicro X9SRW-F User Manual

Rear Unit ID LED (LE2)

The rear Unit ID LED is located at LE2 on
the back panel. This LED is used in con-
junction with the rear UID switch to provide
easy identification of a system that might be
in need of service.

IPMI Heartbeat LED (BD1)

The IPMI Heartbeat LED is located at BD1.
When BD1 blinks, the IPMI feature is func-
tioning properly. Refer to the table on the
right for details. Also see the layout below
for the LED location.

Onboard Standby Power LED (LED2)

An onboard Standby Power LED is located
at LED2. When LED2 is on, this indicates
that the AC power cable is connected and
the power supply hard switch is on. Make
sure to disconnect the power cable before
removing or installing any component. See
the layout below for the LED location.
IPMI LAN
USB/0/1
USB/2/3 KB/MOUSE
JUSBKM
B
A
LE2
C
A
3
C
JI2C3
JI2C2
T-SGPIO4 T-SGPIO3 T-SGPIO2
JPL1
T-SGPIO1
J30
J29
JTPM1:TPM/PORT80
JSTBY1:STAND BY POWER FOR DOM
JTPM1
JTPM1: TPM/PORT80
JBT1:CMOS CLEAR
+
SXB2
SXB1B
Blue: Solid
Off
IPMI Heartbeat LED Indicator
Green: Blinking
Off
Onboard Standby PWR LED (LE4)
Status
Off
On
A. Rear Unit ID LED
B. IPMI Heartbeat LED
C. Onboard Standby Power LED
JI2C1
LE1
J1
J2
J3
J4
DIMM4B
DIMM4A
DIMM3B
DIMM3A
R136
C241
I-SATA3
I-SATA1 I-SATA5
I-SATA0
I-SATA2 I-SATA4
2-33
Chapter 2: Installation
Rear UID LED
LED Settings
UID Toggled On
UID Toggled Off
LED Settings
IPMI is ready for use
IPMI Off
LED Status
Definition
Power Supply is Off (Hard
Switch)
Power Supply is On (Hard
Switch).
DIMM1A
DIMM1B
DIMM2A
DIMM2B
JWF1
1
FAN3
1
JL1 :CHASSIS INTRUSION