Watch Dog Reset (Jwd1); Vga Enable (Jpg1) - Supermicro X10SRG-F User Manual

Watch Dog Reset (JWD1)

Watch Dog (JWD1) is a system moni-
tor that can reboot the system when
a software application hangs. Close
pins 1-2 to reset the system if an ap-
plication hangs. Close pins 2-3 to
generate a non-maskable interrupt
signal for the application that hangs.
See the table on the right for jumper
settings. Watch Dog must also be en-
abled in the BIOS.

VGA Enable (JPG1)

JPG1 allows you to enable or disable
the onboard VGA port. The default
position is on pins 1 and 2 to enable
VGA. See the table on the right for
jumper settings.
LE1 1
JUIDB1
UID-SW
SXB1A
COM1
VGA
COM2
BMC
LEDM1
JPL1
JBRSET1
JPG1
JSTBY1
LE2
BT1
SP1
A
Intel C610
JBT1
X10SRG-F
REV:1.01
2-31
DESIGNED IN USA
CPU
Chapter 2: Installation
Watch Dog (JWD1)
Jumper Settings
Setting Definition
Pins 1-2 Reset (Default)
Pins 2-3 NMI
Open Disabled
VGA Enable/Disable (JPG1)
Jumper Settings
Setting Definition
Pins 1-2 Enabled (Default)
Pins 2-3 Disabled
A. Watch Dog Reset
B. VGA Enable
4
LAN2
LAN1
USB 0/1(3.0)
IPMI_LAN
SXB2A
i350
B
USB 4/5
USB 6/7
USB 8/9(3.0)
JITP1