Loading Roll-Fed Media - Intermec 4630 User Manual

Loading Roll-Fed Media

1. Open the stock door.
2. Raise the printhead latch wing and rotate it counterclockwise one-half turn
to unlock the printhead. Lift the printhead to the raised position.
3. Slide the media roll onto the media hub assembly.
4. Route the media under the bouncer assembly and in between the upper and
lower media guides until it exits the printhead assembly.
5. Adjust the media edge guide until it just touches the edge of the media.
6. Lower the printhead, engage the printhead latch, and rotate the latch wing
clockwise one-half turn to lock the printhead into position.
Note: You may need to feed several labels through the printer before the media is
properly aligned.
1
Getting Started
1-7