To reset the head level adjustment bracket
1. Pull out the head level adjustment knob and turn the knob until the "9" is
2. Loosen the two screws securing the bracket.
3. Load the new media.
4. Slide the bracket up or down to contact the head level adjustment cam.
5. Tighten the two screws to secure the bracket.
6. Print a test label. You may need to turn the head level adjustment knob to
Removing Thermal Transfer Ribbon
Generally, ribbons are completely used before they are replaced. To remove a
completely used ribbon, pull the ribbon straight off the takeup hub. However,
if you need to print in direct thermal mode before the thermal transfer ribbon
has been completely used, you must remove the used portion of the ribbon.
To remove partially used thermal transfer ribbon
1. Cut the ribbon between the idler rollers.
2. Turn the ribbon supply hub to rewind the unused ribbon until it is clear of
3. Turn the ribbon takeup hub counterclockwise to roll up the used ribbon,
in the twelve o'clock position.
fine tune the print quality.
the printhead. Leave the good ribbon on the supply hub until you need to
use it again.
and then slide the ribbon off the takeup hub.
Operating and Configuring the Printer
2
2-15